Pipe Bender Device - Kinds and Kinds

Go down

Pipe Bender Device - Kinds and Kinds

Post  uyyutyuoyu on Fri Jun 01, 2012 5:18 pm

In each kind of device, the process stick to a process. A tube is packed into a bender which is held into place between two passes away. Technical power is used to force the tube against a die which causes it to comply with the appearance of the information. This is often done by spinning or moving its end around it (die).The process above is used in the different sessions of benders listed below. Each bender kind is different in the way it is applicable mechanical power to get the curvature.

pipe bender

Probably the most primary form of bender is the media bender. As the name indicates, mechanical power makes the curvature by pushing the tube against a die. The power is usually used hydraulically or pneumatically, with regards to the settings of it. This form of bender can be used on freezing tube joints but it usually deforms the combination area at the curvature to an square appearance due to the deficit of inner assistance.


Posts : 8
Join date : 2012-06-01

View user profile

Back to top Go down

Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum